Knowledge Agora



Similar Articles

Title Energy recovery of waste plastics into diesel fuel with ethanol and ethoxy ethyl acetate additives on circular economy strategy
ID_Doc 28723
Authors Padmanabhan, S; Giridharan, K; Stalin, B; Kumaran, S; Kavimani, ; Nagaprasad, N; Jule, LT; Krishnaraj, R
Title Energy recovery of waste plastics into diesel fuel with ethanol and ethoxy ethyl acetate additives on circular economy strategy
Year 2022
Published Scientific Reports, 12.0, 1
Abstract The widespread use of plastic goods creates huge disposal issues and environmental concerns. Increasing emphasis has been paid to the notion of a circular economy, which might have a significant impact on the demand for plastic raw materials. Post-consumer plastics recycling is a major focus of the nation's circular economy. This study focuses on energy recovery from waste plastics as an alternative fuel source to meet the circular economy demand. Waste plastic fuel produced through pyrolysis has been claimed to be utilized as a substituted fuel. This work focuses to determine the performance and emission standards of Waste Plastic Fuel (WPF) generated from the pyrolysis of High-Density Polyethylene (HDPE) in a single-cylinder Direct Injection Diesel Engine (DIDE). Three different ratios of WPF were combined with 10% ethanol and 10% ethoxy ethyl acetate as an oxygenated additive to create quaternary fuel blends. The ethanol has a low viscosity, a high oxygen content, a high hydrogen-to-carbon ratio as favourable properties, the quaternary fuel results the improved brake thermal efficiency, fuel consumption and reduced emissions. The blend WEE20 exhibits 4.7% higher brake thermal efficiency, and 7.8% reduced fuel consumption compared to the diesel. The quaternary fuel blends demonstrated decreased carbon monoxide of 3.7 to 13.4% and reduced hydrocarbons of 2 to 16% under different load conditions.
PDF

Similar Articles

ID Score Article
15010 Januszewicz, K; Hunicz, J; Kazimierski, P; Rybak, A; Suchocki, T; Duda, K; Mikulski, M An experimental assessment on a diesel engine powered by blends of waste-plastic-derived pyrolysis oil with diesel(2023)
15108 Alawa, B; Choudhary, J; Chakma, S Discernment of synergism in co-pyrolysis of HDPE and PP waste plastics for production of pyro-oil: Mechanistic investigation with economic analysis and health risk assessment(2023)
17677 Pacheco-López, A; Lechtenberg, F; Somoza-Tornos, A; Graells, M; Espuña, A Economic and Environmental Assessment of Plastic Waste Pyrolysis Products and Biofuels as Substitutes for Fossil-Based Fuels(2021)
15283 Mangesh, VL; Tamizhdurai, P; Krishnan, PS; Narayanan, S; Umasankar, S; Padmanabhan, S; Shanthi, K Green energy: Hydroprocessing waste polypropylene to produce transport fuel(2020)
27442 Gracida-Alvarez, UR; Winjobi, O; Sacramento-Rivera, JC; Shonnard, DR System Analyses of High-Value Chemicals and Fuels from a Waste High-Density Polyethylene Refinery. Part 1: Conceptual Design and Techno-Economic Assessment(2019)Acs Sustainable Chemistry & Engineering, 7.0, 22
16407 Faussone, GC Transportation fuel from plastic: Two cases of study(2018)
20623 Stallkamp, C; Hennig, M; Volk, R; Richter, F; Bergfeldt, B; Tavakkol, S; Schultmann, F; Stapf, D Economic and environmental assessment of automotive plastic waste end-of-life options: Energy recovery versus chemical recycling(2023)Journal Of Industrial Ecology, 27, 5
18770 Kizza, R; Banadda, N; Seay, J Qualitative and energy recovery potential analysis: plastic-derived fuel oil versus conventional diesel oil(2022)Clean Technologies And Environmental Policy, 24.0, 3
14411 Gonzalez-Quiroga, A; Djokic, MR; Van Geem, KM; Marin, GB Conversion of Solid Waste to Diesel via Catalytic Pressureless Depolymerization: Pilot Scale Production and Detailed Compositional Characterization(2016)Energy & Fuels, 30, 10
19254 Jangid, CJ; Miller, KM; Seay, JR Analysis of Plastic-Derived Fuel Oil Produced from High- and Low-Density Polyethylene(2022)Recycling, 7.0, 3
Scroll