| Title | Circular Economy Assessment in Recycling of LLDPE Bags According to European Resolution, Thermal and Structural Characterization |
|---|---|
| ID_Doc | 3123 |
| Authors | Ballestar, R; Pradas, C; Carrillo-Navarrete, F; Canavate, J; Colom, X |
| Title | Circular Economy Assessment in Recycling of LLDPE Bags According to European Resolution, Thermal and Structural Characterization |
| Year | 2022 |
| Published | Polymers, 14, 4 |
| Abstract | According to the Circular Economy Package promoted by the European directive, plastic bags companies must use in their formulations a percentage of polyethylene waste (industrial and/or domestic) greater than 70%. Following that regulation requires an understanding of its consequences in the final product from an industrial point of view. This manuscript analyzes the thermal and morphological changes related to the tear resistance of linear-low density polyethylene (LLDPE) samples from industrial waste generated by the company Sphere Spain subjected to the degradation produced by the recycling cycles. The process is analogue to the industrial, starts from samples in pellets then a film by blow extrusion is obtained (odd steps) and posteriorly this film is recycled to pellets again (even steps). The results obtained show that the LLDPE samples develop two crystalline structures (CS1 and CS2) which evolve differently through the recycling cycles with a tendency to decrease in crystallinity due to degradation that is not the same for the process of obtaining film or recycling to pellet. The molecules with a more linear structure and a longer chain break and branch. The more branched structure increases and tends to crosslinking. This leads to a decrease in tear strength in the longitudinal direction, which is not so evident in the transversal direction. The samples could admit four recycling cycles with and acceptable tear resistance. The longitudinal tear strength value decreases by 40% for each film and 20% in the case of tearing in the transverse direction. The results obtained in this research work show that the regulations included in the cited circular economy package can be applied in the manufacture of consumer bags, helping also to reduce the dependence of manufacturers on fluctuations in delivery by collapses in shipping. |
| https://www.mdpi.com/2073-4360/14/4/754/pdf?version=1644922142 |
Similar Articles
| ID | Score | Article |
|---|---|---|
22183
|
de las Heras, RB; Colom, X; Canavate, J Comparative Analysis of the Effects of Incorporating Post-Industrial Recycled LLDPE and Post-Consumer PE in Films: Macrostructural and Microstructural Perspectives in the Packaging Industry(2024)Polymers, 16.0, 7 | |
| 13555
|
O'Rourke, K; Wurzer, C; Murray, J; Doyle, A; Doyle, K; Griffin, C; Christensen, B; Brádaigh, CMO; Ray, D Diverted from Landfill: Reuse of Single-Use Plastic Packaging Waste(2022)Polymers, 14, 24 | |
| 28934
|
Van Eygen, E; Laner, D; Fellner, J Circular economy of plastic packaging: Current practice and perspectives in Austria(2018) | |
| 17721
|
Zeilerbauer, L; Fischer, J; Fazeni-Fraisl, K; Mager, M; Lindorfer, J; Paulik, C Life cycle assessment of mechanical recycling of low-density polyethylene into film products - towards the need for life cycle thinking in product design(2024) | |
| 28204
|
Mita, L Exploiting The Potential Of Polyethylene Mechanical Recycling: Economic And Sustainability Analysis(2020)Environmental Engineering And Management Journal, 19.0, 10 | |
| 24907
|
Antonopoulos, I; Faraca, G; Tonini, D Recycling of post-consumer plastic packaging waste in the EU: Recovery rates, material flows, and barriers(2021) | |
| 13220
|
van Velzen, EUT; Jansen, M; Brouwer, MT; Feil, A; Molenveld, K; Pretz, T Efficiency Of Recycling Post-Consumer Plastic Packages(2017) | |
| 28793
|
Mastellone, ML Technical description and performance evaluation of different packaging plastic waste management's systems in a circular economy perspective(2020) | |
| 2918
|
Novakovic, K; Thumbarathy, D; Peeters, M; Geoghegan, M; Jefferies, JG; Hicks, C; Manika, D; Dai, S Zero-waste circular economy of plastic packaging: The bottlenecks and a way forward(2023) | |
| 27946
|
Esmaeilzade, R; Stainslavovich, KA; Jandaghian, MH; Hosseini, LSR; Saleh, LH; Zarghampour, S Correlation of structure, rheological, thermal, mechanical, and optical properties in Low Density Polyethylene/Linear Low Density Polyethylene blends in the presence of recycled Low Density Polyethylene and Linear Low Density Polyethylene(2024)Polymer Engineering And Science, 64.0, 3 |