| Title |
Corncob waste as a potential filler in biocomposites: A decision towards sustainability |
| ID_Doc |
13728 |
| Authors |
Gairola, S; Naik, TP; Sinha, S; Singh, I |
| Title |
Corncob waste as a potential filler in biocomposites: A decision towards sustainability |
| Year |
2022 |
| Published |
|
| DOI |
10.1016/j.jcomc.2022.100317 |
| Abstract |
Waste resource utilization is of utmost importance today in order to promote circular economy and sustainable development. The current research work focuses on utilizing post-consumer corncob (CC) waste into value-added products by exploring its potential as a filler/additive in polypropylene (PP) composites. If successful, the added fillers will substitute 5-20% PP without compromising the functional requirements of non-structural (non-load bearing) products. Corncob filler (CCF) at four-filler loadings (5, 10, 15, and 20 wt.%) and two variants of particle size (S-1-100-355 mu m and S-2-355-710 mu m) was melt-compounded using an extruder and then injection molded into composite samples. The effect of filler size and loading was investigated on water diffusion kinetics, mechanical, thermal, and flammability characteristics for analyzing the performance of developed materials during in-service conditions. Thermal and flammability characteristics were analyzed by thermo-gravimetric analysis (TGA), Ul-94 horizontal burning (HB), and limiting oxygen index (LOI) test. CCF-S-1 exhibited better mechanical properties with higher tensile and flexural modulus than CCF-S-2. For 10 wt. % loading, lower size (S-1 filler) showed 5.85% and 2.94% increase in tensile and flexural modulus, respectively than higher filler size S-2. CCF-S-1 filled composites record lowered HB rate than S-2 filler with no notable change in LOI values. The results revealed the possible reuse and utilization of CCF as a reinforcing filler at 10% loading with a filler size of 100-355 mu m. The properties achieved using CCF and extrusion injection molding process are significant enough for non-structural applications such as paper weight, tableware, mementos etc. |
| Author Keywords |
Corncob; Lignocellulosic; Thermoplastic composites; Fick's diffusion; Thermal stability; Flammability |
| Index Keywords |
Index Keywords |
| Document Type |
Other |
| Open Access |
Open Access |
| Source |
Emerging Sources Citation Index (ESCI) |
| EID |
WOS:000906616900024 |
| WoS Category |
Materials Science, Composites |
| Research Area |
Materials Science |
| PDF |
https://doi.org/10.1016/j.jcomc.2022.100317
|