| Title |
Extraction and quantification of polyphosphates in activated sludge from waste water treatment plants by 31P NMR spectroscopy |
| ID_Doc |
14213 |
| Authors |
Staal, LB; Petersen, AB; Jorgensen, CA; Nielsen, UG; Nielsen, PH; Reitzel, K |
| Title |
Extraction and quantification of polyphosphates in activated sludge from waste water treatment plants by 31P NMR spectroscopy |
| Year |
2019 |
| Published |
|
| DOI |
10.1016/j.watres.2019.03.065 |
| Abstract |
Polyphosphate (poly-P) is a major constituent in activated sludge from wastewater treatment plants with enhanced biological phosphorus removal due to poly-P synthesis by poly-P accumulating organisms where it plays an important role for recovery of phosphorus from waste water. Our aim was to develop a reliable protocol for poly-P quantification by P-31 NMR spectroscopy. This has so far been complicated by the risks of inefficient extraction and poly-P hydrolysis in the extracts. A protocol for complete extraction, identification and quantification of poly-P in activated sludge from a waste water treatment plant was identified based on test and evaluation of existing extraction protocols in combination with poly-P determination and quantification by solution and solid state P-31 NMR spectroscopy. The total poly-P middle group content was quantified by solid state NMR for comparison with the poly-P middle groups quantified by solution NMR, which is novel. Three different extraction protocols previously used in literature were compared: 1) a single 0.25 M NaOH-0.05 M EDTA extraction, 2) a 0.05 M EDTA pre-extraction followed by a 0.25 M NaOH main extraction and 3) a 0.05 M EDTA pre-extraction followed by a 0.25 M NaOH-0.05 M EDTA main extraction. The results showed that the extraction protocol 2 was optimal for fresh activated sludge, extracting 10.8 +/- 0.4 to 11.4 +/- 1.2 mgP/gDW poly-P. Extraction protocols 1 and 3 extracted less than 9.4 +/- 0.5 mgP/gDW poly-P. A comparison of the quantification of poly-P by P-31 solution NMR and by P-31 solid state NMR spectroscopy of lyophilised activated sludge showed 86 +/- 9% extraction efficiency of poly-P, which confirms that the extraction protocol recovered most of the poly-P from the samples without pronounced poly-P degradation. (C) 2019 Elsevier Ltd. All rights reserved. |
| Author Keywords |
Polyphosphate; Identification; Quantification; P-31; Solid state NMR; EBPR; Biological waste water treatment |
| Index Keywords |
Index Keywords |
| Document Type |
Other |
| Open Access |
Open Access |
| Source |
Science Citation Index Expanded (SCI-EXPANDED) |
| EID |
WOS:000468253500034 |
| WoS Category |
Engineering, Environmental; Environmental Sciences; Water Resources |
| Research Area |
Engineering; Environmental Sciences & Ecology; Water Resources |
| PDF |
https://findresearcher.sdu.dk/ws/files/153571096/Stall_et_al..pdf
|