| Abstract |
The ease with which modern plastics can be injection molded makes them very suitable for the production of many different products and, today, plastics are often used as substitutes for metal. Polypropylene (PP) is one of the most widely used thermoplastics globally since it is very useful, cost-effective and flexible for molding. However, the amount of harm to the environment caused by plastic waste has become phenomenal and the recycling of plastics has become a serious aspect of environmental protection. PP, as the most commonly used plastic material, was selected for use in this study. It has a melt flow index of 15 g/min and its recyclability, fluidity, and physical properties, as well as manufacturing conditions, were explored in relation to the number of times the material could be recycled (TR). A cavity pressure sensor was used to measure the viscosity index of the recycled plastic after multiple cycles of plasticizing and injection, part molding, scrap-recycling, and crushing. A paperclip-shaped test specimen was used to determine PP fluidity and crystallinity of specimens with different TRs. Tensile tests were used to detect differences in the tensile strength between specimens made from Raw-PP and recycled PP. The results showed that PP that had been recycled several times had a higher melt flow index, material fluidity, melting peak area, crystallinity, crystallization rate, and crystallization temperature. Repeated injection and recycling of the material had reduced the length of the molecular chains and broadened the molecular weight distribution. This improved the fluidity and increased crystallinity. The increase in fluidity made cavity filling easier, reducing the cavity pressure as well as the viscosity index. The results of this study showed that the recycling of the PP could improve the physical properties of the products to a degree and also went some way to further the benefits of a circular economy. The recycling of injection-molded PP material can be added to renewable energy technologies and used in environmental impact assessment. |