| Title |
Design of experiments to compare the reprocessing effect with Fused Deposition Modeling printing parameters on mechanical properties of Polylactic Acid specimens towards circular economy |
| ID_Doc |
28237 |
| Authors |
Kuclourya, T; Monroy, R; Ahmad, R |
| Title |
Design of experiments to compare the reprocessing effect with Fused Deposition Modeling printing parameters on mechanical properties of Polylactic Acid specimens towards circular economy |
| Year |
2023 |
| Published |
Progress In Rubber Plastics And Recycling Technology, 39.0, 2 |
| DOI |
10.1177/14777606221145702 |
| Abstract |
Distributed Recycling via Additive Manufacturing (DRAM) is a closed-loop material reprocessing solution that promotes circular economy. There are several literature gaps related to material properties and recycling cycles at different stages of the DRAM process. With an approach to filling these gaps, a small contribution has been made through this work by comparing the effect of reprocessing cycles (recycling) with the effect of FDM printing parameters such as Raster angle orientation, Infill density and Extrusion Temperature. These four parameters are ranked based on their impact on the tensile properties of Polylactic Acid (PLA) dog bone specimens. The Design of Experiments via Taguchi Analysis is carried out to avoid analysis of a large number of samples. The results show that recycling has the maximum impact on the tensile properties of PLA samples and can reduce the tensile strength by up to 75% in the course of four reprocessing cycles. The specimens had Ultimate Tensile Strength (UTS) values in the range of 20-26 MPa at the first reprocessing cycle which dropped significantly to a range of 7-9 MPa after the fourth reprocessing cycle. Additionally, a novel analysis on time and the number of specimens to be 3D printed at each reprocessing stage has also been conducted to help future researchers manage their printing schedule, especially in the recycling domain. |
| Author Keywords |
circular economy; reprocessing; Fused Deposition Modeling; raster angle; infill density; extrusion temperature; taguchi analysis |
| Index Keywords |
Index Keywords |
| Document Type |
Other |
| Open Access |
Open Access |
| Source |
Science Citation Index Expanded (SCI-EXPANDED) |
| EID |
WOS:000896877800001 |
| WoS Category |
Materials Science, Composites; Polymer Science |
| Research Area |
Materials Science; Polymer Science |
| PDF |
https://doi.org/10.1177/14777606221145702
|