| Title |
Synthesis and Characterisation of ASA-PEEK Composites for Fused Filament Fabrication |
| ID_Doc |
7217 |
| Authors |
Palacios-Ibanez, B; Relinque, JJ; Moreno-Sanchez, D; de Leon, AS; Delgado, FJ; Escobar-Galindo, R; Molina, SI |
| Title |
Synthesis and Characterisation of ASA-PEEK Composites for Fused Filament Fabrication |
| Year |
2022 |
| Published |
Polymers, 14, 3 |
| DOI |
10.3390/polym14030496 |
| Abstract |
In this paper, a series of polymer composites made from acrylonitrile-styrene-acrylate (ASA) and poly (ether ether ketone) (PEEK) were manufactured. ASA acts as a polymer matrix while PEEK is loaded in the form of micro-particles that act as a reinforcing filler. The composites were compounded by single screw extrusion and then, different specimens were manufactured either via injection moulding (IM) or fused filament fabrication (FFF). Two different types of PEEK (commercial and reused) in different concentrations (3 and 6 wt.%) were tested and their influence in the mechanical, structural, and thermal properties were studied. It was observed that reused PEEK enhanced the stiffness and tensile strength and thermal stability of the composites both, for injected and printed specimens. This evidences the suitability of these composites as potential candidates as novel materials with enhanced properties following an approach of circular economy. |
| Author Keywords |
thermoplastic polymers; composite materials; fused filament fabrication; mechanical properties; thermal properties |
| Index Keywords |
Index Keywords |
| Document Type |
Other |
| Open Access |
Open Access |
| Source |
Science Citation Index Expanded (SCI-EXPANDED) |
| EID |
WOS:000760148200001 |
| WoS Category |
Polymer Science |
| Research Area |
Polymer Science |
| PDF |
https://www.mdpi.com/2073-4360/14/3/496/pdf?version=1643358470
|