| Title | Material flow analysis and sustainability of the Italian plastic packaging management |
|---|---|
| ID_Doc | 5294 |
| Authors | Lombardi, M; Rana, R; Fellner, J |
| Title | Material flow analysis and sustainability of the Italian plastic packaging management |
| Year | 2021 |
| Published | |
| Abstract | The plastic management, specifically plastic packaging management, represents one of the main sectors responsible for environmental and health impacts. The European Commission, in 2018, released a Strategy for Plastics in a Circular Economy and a new Packaging Waste Directive for closing the loop of this management system, forcing member states to recycle 55% of plastic packaging by 2030. The level of circular economy in a supply chain can be measured with material flow analysis, a useful tool to help policy makers forecast the recycling capability and to provide suggestions for improving the plastic packaging management sustainability. Considering the gap in literature in this field, the principal aim of this paper is to apply material flow analysis to measure the level of circular economy in the 2017 Italian plastic packaging management, by using the software STAN 2.6. Particularly, it assessed its post consumer recycling rate, according to the new calculation method established by the Waste Directive. Secondly, this result is compared with that of the other EU-28 countries. The findings indicate that Italy has a good recycling rate, almost 44%, and that the energy recovery and landfill levels are about 40% and nearly 17%, respectively. There is room for making plastic waste management more efficient. Some of the EU-28 countries have wide margins of improvement thanks to large amounts of plastic packaging in landfills, whereas others, although they present good recycling rates, could tackle some problems in adopting the circular economy approach because they continue to burn plastic packaging in waste-to energy plants. (c) 2020 Elsevier Ltd. All rights reserved. |
Similar Articles
| ID | Score | Article |
|---|---|---|
15563
|
Lopez-Aguilar, JF; Sevigne-Itoiz, E; Pena, M; Pena, J A realistic material flow analysis for end-of-life plastic packaging management in Spain: Data gaps and suggestions for improvements towards effective recyclability(2022) | |
| 28934
|
Van Eygen, E; Laner, D; Fellner, J Circular economy of plastic packaging: Current practice and perspectives in Austria(2018) | |
| 16675
|
Gonçalves, M; Freire, F; Garcia, R Material flow analysis and circularity assessment of plastic packaging: An application to Portugal(2024) | |
| 28930
|
Scriosteanu, A; Criveanu, MM Green and Reserve Logistics of Packaging and Plastic Packaging Waste under the Conditions of Circular Economy at the Level of the European Union Member States(2024)Energies, 17.0, 12 | |
| 6044
|
Baran, B Plastic waste as a challenge for sustainable development and circularity in the European Union(2020)Ekonomia I Prawo-Economics And Law, 19, 1 | |
| 690
|
Czarnecka-Komorowska, D; Wiszumirska, K Sustainability design of plastic packaging for the Circular Economy(2020)Polimery, 65, 1 | |
| 24907
|
Antonopoulos, I; Faraca, G; Tonini, D Recycling of post-consumer plastic packaging waste in the EU: Recovery rates, material flows, and barriers(2021) | |
| 17924
|
Picuno, C; Alassali, A; Chong, ZK; Kuchta, K Flows of post-consumer plastic packaging in Germany: An MFA-aided case study(2021) | |
| 26276
|
Van Eygen, E; Laner, D; Fellner, J Integrating High-Resolution Material Flow Data into the Environmental Assessment of Waste Management System Scenarios: The Case of Plastic Packaging in Austria(2018)Environmental Science & Technology, 52, 19 | |
| 4279
|
Pincelli, IP; Júnior, ABD; Matias, MS; Rutkowski, EW Post-consumer plastic packaging waste flow analysis for Brazil: The challenges moving towards a circular economy(2021) |